VST MIDI NOTE RECORDER LOOPER PATCH

VST MIDI NOTE RECORDER LOOPER PATCH

There are quite a few out there on iOS, like MIDI Patch Bay, MIDI Flow, etc. This will offer some extra controls over the Looper and DAW section in stand-alone.Īs for (6) and (7), I would suggest looking at different MIDI routing, filtering, and editing apps. In regards to (5), for a full list of MIDI controls in AmpliTube, use the MIDI menu in the lower right hand corner. but I'll be missing my virtual Rigĭaniel d10221 Posts: 22 Joined: Sun 3:58 pmįor (4), unfortunately, AmpliTube 4 does not offer the Looper in VST/AU instances. Is there a way to Map Loop-Clear to MIDI events ?Ħ) Software Midi Patch Map Translate *PC top *CC withħ) A MIDI controller that can send *CC instead *PCĨ) Give up and by a Looper pedal.

Result same as (2) but potentially could feed more controllers to Amplitube (it Should listen to All ports by default, to don't need to fiddle with extral Midi Apps)Įxpected: too much setup, not live friendly?ĥ) Ext1 from STOMP_I/O to Single Loop ( Loop#1), hoping the switch will send only 1 CCl, and EXT2 to Global Play Result: Kind of Ok, when manually mapping Loop#1 to Amplitube seems confused by the 2 MIDI events sent together (1 and 127) by the Stomp, control changes are OK as they are straight 'program changes',ģ) External controller via USB and the STOMP patched and routed to IAC Bus the Amplitube in IAC bus, Result: Good looper control, hard/slow to change presets or go to stomp modeĢ) STOMP in Port 1 with an external MIDI patch changer connected to the STOMP's MIDI IN, to use the Looper and change presets without leaving the looper mode if the Bluetooth latency is not an issue, I have't tried my selfġ) I've been using it with the STOMP-I/O in integration mode It doesn't look like, but it could be great to leave the STOMPIO for stomps and *PC Is it possible to use the Blueboard and the STMOPIO at the same time ?

Vst midi note recorder looper